- State: Arizona
- Country: Ashmore and Cartier Island
- Listed: November 28, 2018 1:44 am
- Expires: This ad has expired
Viewing angle:120 deg
The materials of the LED dice is InGaN
RoHS compliant lead-free soldering compatible
Low Voltages series
High Voltages series
2835 0.5W 18302800-3200K/4000K-4500K/5500-6500K70-8070-90
● Intensity Bin Limit (IF = 60 mA)
Bin codeFlux(lm) for reference
● VF Bin Limit (IF = 60 mA)
● Chromaticity CIE
● Color Bin Limit (IF = 60 mA)
●Requirements for application and reflow soldering
120 seconds Max.
10 seconds Max.
Refer to Temperature-profile
After reflow soldering rapid cooling should be avoided
Temperature-profile(Surface of circuit board)
Use the following conditions shown in the figure.
1.Reflow soldering should not be done more than two times
2.When soldering,do not put stress on the LEDs during heating
Applications of 2835 SMD LED:
●All kinds of strip and tube.
●Switches, keys backlighting
●Electronic display panel light
●Marker lights,reading lamps.
●Outdoor backlighting displays.
●External and internal automotive lighting.
●Panel light,candle light,downlight ,bulb lights.
●Emergency lighting,signal and symbol luminaire, Ect.
Packaging & Delivery
4000pcs/reel, each reel Anti-static vacuum Bag
Shipped in 3-5 days after payment
Before opening the package:The LEDs should be kept at 5~30°C and 60%RH or less. The LEDs should be used within a year. After opening the package:The LED must be used within 24 hours, else should be kept at 5~30℃ and 30% RH or less. The LEDs should be used within 7days after opening the package. If unused LEDs remain, they should be stored in moisture proof pachages .recommend to return the LEDs to the original moisture proof bag and to reseal the moisture proof bag again. If the LEDs have exceeded the storage time, baking treatment
should be performed more than 24 hours at 60 ± 5°C.
When hand soldering, keep the temperature of iron below less 300℃ less than 3 seconds
The hand solder should be done only one times
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed in advance whether the characteristics of LEDs will or will not be damaged by repairing.
1.Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible. Although its characteristic significantly reduces thermal stress, it is more prone to damage by external mechanical force . As a result, Special handling precautions must be observed during assembling using silicone encapsulated LED products, Failure to comply might leads to damage and premature failure of the LED.
2.Handle the component along the side surface by using forceps or appropriate tools; do not directly touch or Handle the silicone lens surface, it may damage the internal circuitry.
3.The outer diameter of the SMD pickup nozzle should not exceed the size of the LED to
prevent air leaks. The inner diameter of the nozzle should be as large as possible. A pliable
material is suggested for the nozzle tip to avoid scratching or damaging the LED surface during
pickup. The dimensions of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production.
4.Do not stack together assembled PCBs containing LEDs.Impact may scratch the silicone lens or damage the internal circuitry.
5.Not suitable to operate in acidic erivironmengt.PH